TRIMMING THE FIBERGLASS
MATERIALS

To Trim off the excess fiberglass you will need some type of cutting tool. You can use a Dremel Tool (or equivalent) with some good cutting attachments.  The cutting disks that I used kept ringing off the shaft, so I switched to the next tool below.

Here is a much heavier duty grinding tool. It made the job a lot faster, but the size and design make it hard to get into the tight spots.

Your standard Sand-Paper. For smoothing off any rough areas. (fairly self explanatory)

Dust Mask / Respirator
When grinding and sanding Fiberglass always use a mask or filter over your mouth and nose to prevent breathing the dust.

Safety Goggles
Always wear Safety Glasses when using any power tool.

Next: Trimming the Fiber-Glass Cont.

HOME | ARMOR | GALLERY | HOW TO | ORDER | CONTACT | LINKS | CONVENTIONS